What do you guys think of this pressure plate surface?

[boosted86]

just as the title states, this guy is selling this competition 2300 pp plate, he stating it has roughly 10k on it.. what do you guys think?

 

[droppinbottom]

Put a straight edge across it and see how much it is warped. Granted a used one will be warped a little no matter how much care was used in taking it off.

 

[romeen]

Run your finger over the friction surface. As long as it feels smooth and you don't feel any irregularities where the heat smears are you should be ok.

 

[RedTurboEclipse]

Run your finger over the friction surface. As long as it feels smooth and you don't feel any irregularities where the heat smears are you should be ok.

ditto, should not try and resurface it either.

 

[boosted86]

also, the reason that im doing this clutch swap is that i was stupid and installed a stock clutch on a 300whp car....2k miles later, slipping like a mofo. my question is when i did that clutch swap about 2k miles ago, i bought a new oem throwout bearing, do you guys think its still good? thanks.

 

[snowborder714]

A new one is less than $30. I'd get one for piece of mind.

 

[Defiant]

Scorched to hell. Skip.

 

[boosted86]

Scorched to hell. Skip.

thanks defiant.