What the heck is this

[Trowsk]

well heres the link, its the circular thing its olmost like a vaccum hose or something for some reason it blew off yesterday.... yes i was hot rodding my car but now it just makes a hissing noise so i capped it with a screw and its idling better now any ideas or suggestions would be much appreciated

<a href="http://s68.photobucket.com/albums/i8/STUDLY-1/?action=view&current=DSCF0165-1.jpg" target="_blank"><img src="http://i68.photobucket.com/albums/i8/STUDLY-1/DSCF0165-1.jpg" border="0" alt="Photobucket"></a>

http://i68.photobucket.com/albums/i8/STUDLY-1/DSCF0165-1.jpg

 

[r1991_4g63t]

the base idle set screw is SUPPOSED to be there...

 

[GSX93DSM]

That would be the idle screw the is a rubber cover that goes over top of the hole. If it is hissing you need to change the o ring. Mitsubishi has them both for 3.00.

 

[Trowsk]

Lol and where do you think it went or what im really asking how would it come off if its a vaccumm. and how could i get another one .... and is it ok just to cap it off with something else ?

 

[95tzlgst]

But he is right the base idle set screw is suppose to be there.

 

[r1991_4g63t]

if the orings are bad its possible for the screw to walk itself out under boost

 

[Trowsk]

can anyone take a close picture of theirs to show me what its supposed to look like ive looked everywhere and cant find one

 

[GSX93DSM]

You can do without the cap. Go to Mitsu and tell them you the the idle screw and o ring. They will hook you up.

 

[Trowsk]

alrighty ty much what about autozone or o'reilys ?

 

[ROOKIE1]

Read this .
1G BISS Adjustment

 

[GSX93DSM]

I doubt it, I believe its a dealer part, unless you get it at a place like DSMPARTS.com

 

[xveganxcowboyx]

Just call your local mitsubishi dealer and order a new BISS/Base Idle Screw with the O-Ring. It is literally just a screw that threads into that hole. There is an O-ring around the screw that forms an air tight seal. The screw turns in and out letting more or less air through to adjust your idle speed. It's very simple. Buy screw, slip on O-ring, screw in. There is a write up on VFAQ.

Also, there is a plastic cap that fits into the hole on to of the screw, but it is not particularly important (at least much less than the screw itself)

 

[95tzlgst]

hope this helps

 

[95tzlgst]

EXTREME PSI : Your #1 Source for In Stock Performance Parts

 

[Trowsk]

theyre all saying theyre out of stock maybe ill bum one off my friends eclipse


TY for above link

do i need all three of these

or just the o ring and the screw ?

EXTREME PSI : Your #1 Source for In Stock Performance Parts

 

[ROOKIE1]

Yes , the cap hold the screw so it can't back out .

Did you try a Mitsu dealer ?

Also try Chrysler dealer . Just tell them you have an Eagle Talon .

 

[Trowsk]

sweet ordered ty much all for your fast imput

 

[ROOKIE1]

Where from ?

 

[Trowsk]

EXTREME PSI : Your #1 Source for In Stock Performance Parts