where is the crank angle sensor on a 2g

[xdrugxfreex]

i am putting on a 1g head and trying to find how to wire in the cas and i read a site that said you need to wire in the crank sensor too so i was wondering where it was located thanks

 

[97 4G63]

Behind the crankshaft pulley on the timing belt side.
This may help.
http://www.dsmtuners.com/forums/articles-electrical-wiring/289870-installing-1g-cas-2g.html

 

[thatblondechik]

I've searched around the forums and I'm having a hard time finding the answer I'm looking for.
I have a 97 Eclipse GST and the CAS is on the passenger side (which I've been told I can use to adjust timing) and I'm fixing to do a swap with an engine out of a 96 and the CAS is on the other side behind the cam gear. What I'm trying to figure out, is how do I switch that 96 engine so that the CAS is on the passenger side instead of the drivers side?
I had a friend of mine try to explain it to me, but for some reason it just confused the hell out of me.

 

[ReaperGSX]

Since you have a 2G this is site rules.

Virtual Tour of the DSM Engine Bay - Quadrant map

 

[thatblondechik]

I've searched through the forums once again, and I'm still coming up with nothing. Can anyone point me to a tech article or share some first hand knowledge on how to swap the CAS so that I can adjust timing on a 96 7 bolt?

 

[1992awdlaser]

This should help. http://www.magnusmotorsports.com/tech/1gina2g.pdf

It tells you what to do with a 6 bolt cam sensor so it should be the same.

 

[blcknspo0ln]

This should help. http://www.magnusmotorsports.com/tech/1gina2g.pdf

It tells you what to do with a 6 bolt cam sensor so it should be the same.

Damn, I can never give you any new rep points because it says I have to give other members points before I can re-give to you. sorry

Another good writeup by my buddy Jeff

http://www.dsmtuners.com/forums/articles-electrical-wiring/289870-installing-1g-cas-2g.html

 

[luv2rallye]

2g cps picture: http://www.dsmtuners.com/forums/att...t-sensor-whatttttt-crankpositionsensor2gt.jpg

 

[racker]

i did exactly that info. now i have the question if the mark for the cams they need have in the midle after insert the CAS.