turbo back exhaust on stock 7 bolt

[turbo_chick]

Is it worth putting a turbo back exhaust (RRE DP + RRE Test Pipe + APEKi N1 to be exact) on a stock engine that only has a manual boost controller, intake, turbo timer and intercooler? That is also a project car that later this year will get a 6 bolt swap and these are just minor upgrades. Also is there a difference between the AWD N1 and FWD N1 exhausts?

Thank you

 

[snox135]

Yes it will help a little bit. They will become a bigger benefit when you upgrade the turbo. I'm not sure about the FWD and AWD exhaust being different.

 

[dSmgs-T]

that would be the best mod to do next from what you have already. with your car being a gst (fwd) you will obviousy have to go with the FWD system.

 

[EclipseTical]

the AWD exhaust will not fit your car, the piping runs completely different than on a GST.

 

[viperlp01]

...difference between the two is the bends in the pipe. There are many diff bends mainly at the downpipe getting around the transfer case and getting around the rear axle

 

[drdouglas]

If I was going to do it again, I probably would have left the stock exhaust on, but put on a apexi N1 downpipe and weld in a 3" electronic cut out right after the downpipe. It will look stock, but as soon as you open up the exhaust it sounds like a diesel truck with a turbo spooling all the time even at idle.