Gap between headlights and bumper >:|

[always_broken]

Well, I think I pinpointed it but I just need some reassurance.

I installed a fmic awhile back and I remember I took out the core bumper assembly.

It's been bugging me, I screw the 10mm's from the sidemarker areas and the top bolt holes on the bumper. But I always have that gap. It's pretty bad...

I noticed there's a tab for a bolt to go through on the bumper where the headlights sit on top of, but I don't see nothing for it to grab on to.

2gb conversion on 95

 

[blair6389]

There should be two plastic studs that guide through the holes and then two holes for bolts. The bolts should go through to a welded in nut to thread into.

 

[always_broken]

There should be two plastic studs that guide through the holes and then two holes for bolts. The bolts should go through to a welded in nut to thread into.

I got that part, it's the tab where the headlight sits on top of.

I looked at a pic and it showed it was the bumper support..lmk

 

[blair6389]

Oh the two tabs that go into the bumper support? Two plastic screw poppers that are on that metal bracket that mounts into the bumper support?

 

[always_broken]

here's a pic:

 

[blair6389]

Yea thats it. Is it sagging there?

 

[always_broken]

Yea thats it. Is it sagging there?

Yes....

 

[blair6389]

Yes....

and you don't have a front bumper support now?

 

[always_broken]

Just the little nubs, not the complete support.