Question on using Torco fuel concentrate accelerator for tuning

[96gstdsm]

Ok well my car once up and running I am going to get it dyno tuned. I was looking at race gas for a little while, and then I saw Torco concentrated unleaded race gas. I really don't know anything about race gas. That being said, if I tune for a pump gas(93, don't know if there is 94 around me anywhere) what would happen if I use the accelerator Torco stuff in my gas tank? Will it improve anything without being tuned for it? Would I be able to run higher boost with just putting it in, or would I have to make a whole different fuel map to run it? This is for a daily driver strictly. I will normally not drive it hard but since with turbo's can just lay off the gas, if it is safe to run higher boost might as well.
Also would I notice a difference in ability to run higher boost as well as lower knock, if I have any, with only using a smaller amount per tank? Like half a bottle or a quarter bottle?
Is there an equation as to what the concentrate equals, when mixed with 1 gallon of 93 octane gas? Like how many oz per 1 gallon of 93 it takes to make a noticeable difference.
Are there any negative effects of using the Torco stuff for a prolonged period?

 

[GVR4592]

You would have to tune for the new fuel. You might want to contact AMS I believe they tested this stuff on some Evo's.

 

[96gstdsm]

Ok Don't know much about the ecu+ that I got to tune my car with yet, but hopefully I can store multiple tunes with it. Would assume I would be able to. Anyone have experience with ecu+?