420a 2.2 Stroker

[96eclipsex]

Do any of you think that this motor would be able to crank out about 500whp, and even if it can, could it be a daily driver??


2.2 Litre Stroker Create Motor Long Blocks comes with the following parts installed. This is a replaces a 2.0 litre, out side demetions are the same. Clevite 77 Rod Bearing Set

Clevite 77 Main Bearing Set

Total Seal Piston Rings

New Carter Water Pump

All gaskets and Seals

Melling Oil Pump

Eagle Specialty Forged Rods

JE Pistons in your choice of 8.6, 10.5 or 12.5 compression

16 Eaton PT Cruiser Lash Adjusters (Lifters)

16 PT Cruiser Cam Followers (Rockers)

Timing Belt

Complete Head Gasket Set

1 Pair of Crane DOHC Cams 431-0010, 431-0012, or 431-0014 (For 431-0016 or 431-0018 add $50)

1 Pair of AEM Adjustable Cam Gears

Crane Valve Springs

set of stainless steel valves

Seasoned Block and head

Blocks are bored and honed with a deck plate to insure that the cylinder walls are true.

Crankshaft and rotating assembly are race balanced

Cylinder head; Smooth the casting, and blend the seats, full race port with reshaped ports, reshaped combustion chamber, and full port matching.

Cams are degreed for proper centerline All clearances are blue printed

 

[95blackGsTurbo]

It better be able to with those parts. Only one way to find out.

 

[Locutus78]

Ask whoever is building it for a refrence, and call them. That engine sound expensive.