Problems with SBR T28 turbo gaskets

[ILLiCliPSE]

Im currently installing a t28 on my 99 GSX, and the new gaskets that I got from SBR dont exactly line up. The one Im most concerned about is the turbo to o2 housing gasket. the part of the turbo where the flapper for the wastegate is/ where the wastegate hole is, the gasket overlaps this hole. Should i dremel it out as much as i can? Will this cause a problem with exhaust flow?

 

[CanadianTSi]

Yes just Dremel it to match.

 

[ILLiCliPSE]

Yes just Dremel it to match.

yes but the bigger exhaust hole next to it, the main exhaust hole on the gasket, is bigger than the actual hole...so i dont htink i could dremel it flush, since i would probably make one big hole. hope you understand what im tryin to say. Ill just dremel it and get it as close as possible