eltoshan
10+ Year Contributor
- 51
- 0
- Oct 26, 2009
-
Pittsburgh,
Pennsylvania
I just recently bought a 2G that is in pieces, so I'm in the process of assembling the engine still. The head was rebuilt so I figured I should find out how much was milled in the process, but I have to measure the head since there is no markings on the head.
In the factory service manual, it says that the head is around 5.193-5.201 inches tall, is that measured from the deck to the top of the valve cover or is that measured from the deck to the top of the rocker arm?
In the factory service manual, it says that the head is around 5.193-5.201 inches tall, is that measured from the deck to the top of the valve cover or is that measured from the deck to the top of the rocker arm?
