RPM wire pulled out of CAS

[talontsi01]

I just installed my maf translator. While installing, the rpm wire going into the CAS came unhooked from the harness. I put it back in the best i could and it seems like it would be fine.

How can i permenantly get this wire securely back into the CAS harness.

Also, if I did drive my car, and the rpm wire came loose from the CAS harness while driving, what would happen?

 

[fwdtsi]

I would say solder it on there. Also Which wire did you tap on the CAS. Was it the balck wire by the white wire?

 

[btrux06]

is it ok to run a wire from your tach rpm signal wire to the translator rpm wire and not from tha cas?