Crank tolorance

[rookieupgrade1]

I just measured my crank...........(that sounds bad)

Anyhow it is .001 out of round. You think I should have it turned or am I being too picky. (damn it sucks being a machinist sometimes)

Opinions

 

[hostile]

http://www.ecanfix.com/users/manualcd/gift/dsm/1g-90-92-4g63overhaul.pdf

I think it might tell you some of that info in this pdf. If not it is still worth reading...

 

[hostile]

Ahh page 102...
Standard value .0008-.0020
Limit = .004 inches.

 

[rookieupgrade1]

I have that pdf too. It seems I may have overlooked the part I needed.

out of roundness of lournal and pin .o1mm or .0004in

Seems a little tight but better safe. I'll have it turned.