blown t-25 = 14b for my 2g

[paperboy]

well, guess you guys were serious when you all said a t-25 wouldnt last at 20lbs of boost , kinda figured. just got my hands on a 14b and the install is just about done. couple quick questions.... i ported the step
out of the exhaust side of the turbo and manifold and found a pretty
decent size crack on the turbo. dont think it goes all the way through
but looks like it goes right into the wastegate port, under the flapper.
is it possible to have a weld put on these or is it just surface.
also i had to run a bigger oil feed line, is it possible to dump more oil
in faster than it can drain? any help would be coo

 

[paperboy]

also this turbo isn't new, but should i give ii any sort of break in?
or is there a good way to pre-oil?

 

[TurboTerror]

Yeah, I wanna know about this crack thing also. I was going to weld the crack in my 14b but I haven't yet...

 

[Rogue_Ant]

The cracks are very common, and I don't think it is too much to worry about.

About your feed line upsizing...I doubt it will be too much of an issue, but you do want bigger drain line, then the feed line.

Rogue