building fwd 1g exust

[boostin1g]

ok i need to know what bends i need to make a 2.5 or 3' cat back also what bend do i need to make a 2.5 or 3' down pipe

 

[eclipse90gsxt]

My car is awd but I used 1 90 degree bend....1 straight piece for the DP. The middle section is 2 straight pieces. Then the back portion(awd remember) is a 45 towards the back pass corner with a very small straight section to another small 45 then small straight piece to the muffler. I would follow the stock exhuast route but use bigger pipes. Its not that hard to do.

 

[boostin1g]

awd is dif and theres 10 inchs of snow out im just not wanting to go out and try to look under there to find out but i want to order all my parts so this summer i can just take a week or 2 and put everything in

 

[Budget90GST]

For the downpipe-

2 - 45
1 - 90
1- flex
2 - flanges

For the cat back-

1 - u - bend
1 - 90
2 - 45
1 - muffler
1 - resonator ( or long straight pipe)
1 - flange

A cat between the two because it's the legal way . Don't try to do it with less, you'll end up rubbing all over the palce.

Reuse all hangers if in good condition.
Good luck!

 

[realhp=turbo]

You can buy all those parts pre-made from the internet you know.