GM MAF in UICP

[illeagle_talon]

I have a 3" GM MAF and I'm just waiting on the translator but a question dawned on me. With my FMIC setup, my Upper ic pipe is for a non abs so there is not much room between the BOV flange and the throttle body elbow for the MAF along with the transitionary couplers. I know I'll have to do some cutting and trimming on the pipe but I really want to do the blow through setup. Anywho, I was just wondering if anyone out there had any pics or advice of how they mounted theirs on their Non-ABS pipe. Any help would be very much appreciated.

 

[1fast97gsx]

I have a 3" GM MAF and I'm just waiting on the translator but a question dawned on me. With my FMIC setup, my Upper ic pipe is for a non abs so there is not much room between the BOV flange and the throttle body elbow for the MAF along with the transitionary couplers. I know I'll have to do some cutting and trimming on the pipe but I really want to do the blow through setup. Anywho, I was just wondering if anyone out there had any pics or advice of how they mounted theirs on their Non-ABS pipe. Any help would be very much appreciated.

non abs pipe??? How would that matter at all? You just take silicone reducers and cut a section out of your piping ... put those and the gm maf between there. If need be move the bov so its not in the way.

 

[TURFNNSURF]

I have ABS, but i'll show you my UICP that had to be cut to fit the GM MAF in a blow thru setup. The section with the BOV used to go all the way to the throttle body elbow.

You must be logged in to view this image or video.

 

[My96AWD]

I have ABS, but i'll show you my UICP that had to be cut to fit the GM MAF in a blow thru setup. The section with the BOV used to go all the way to the throttle body elbow.

You must be logged in to view this image or video.

does your plug cover say vtec on it?

 

[Stapl3]

VTEC THIS! [middlefinger]

 

[TURFNNSURF]

MY96AWD,

IT says this..

You must be logged in to view this image or video.

 

[My96AWD]

heh. thats different, i have never seen that. bet you get some wired looks from honda guys when youpop your hood. :laugh: looks good but you need an im to finish that engine bay off.

 

[kobykris]

This is how mine is stuffed in the bay, gotta use the left nut cost couplers :hs:

You must be logged in to view this image or video.