greddy 24 front mount IC any one have with dyno results??

[GstRacer]

ok i have 260 fwhp and 230 fwtq just wondering what i could be looking at since i ordered my greddy front mount thanks

 

[ozzeran]

ok i have 260 fwhp and 230 fwtq just wondering what i could be looking at since i ordered my greddy front mount thanks

just curious what mods you have? how is the traction (from a stop and roll) i'm just trying to have some more reasons to keep my GST.

 

[CanadianTSi]

ok i have 260 fwhp and 230 fwtq just wondering what i could be looking at since i ordered my greddy front mount thanks

Were going to need a little more Info than that....

 

[al5dsm]

It will probably very from car to car

 

[blitz43]

same here....
all of my stuff was stolen so im back stock
(thanks to the insurance)

so any i deas would be good

 

[kpt4321]

Yeah, we need to know what turbo, what boost level, what type of fuel, more information about tuning, what intercooler you are running now....

Even then, we can only guess.

 

[heavyD]

Yeah, we need to know what turbo, what boost level, what type of fuel, more information about tuning, what intercooler you are running now....

Even then, we can only guess.

You mean no one has a "crystal ball" or the "mirror on the wall" to help this guy out>

 

[GstRacer]

apexi downpipe injen intake nology plugs and wires greddy evo exhaust greddy type S BOV ported 16G turbo and wstegate DSS upper IC pipe dejon tool lower IC pipe rewired 255 fuel pump ported o2 houseing ported evo3 Manifold AFC2 grounded motor this is what i have traction i have 18s with toyo proxes sh*t tires lowered 2 inches and tokiko 5 ways and i have no traction first and almost all of second when boost hits in firts at about 3500 the tires spin and second keeps spinning till about 5000 to 5500ish but i kinda like to spin tire not trying too and i like that it dosen't put as much strain on my drivetrain as much ass awd i mean an awd launch is awsome dont get me worng but it's a lot of stain on your drivtrain for a daily driver IMO

 

[Krmnnghia]

and...BREATH! WOW long sentance!

 

[CatchMe]

Here is everything done to my car, im running about 21psi on the evo16g with the Greddy FMIC - I put down 348whp and 306 tq. with minimal tuning on 93oct. and a bit of xylene

Engine:
4G63 6 Bolt motor swap
DSM link Engine managment system
JE pistons 9:0:1
Eagle rods
Balance shaft removal kit
EGR block off
DNP tubular exhaust manifold
Tial 40mm external wastegate
Stainless oil feed line
Ported Evo III 16G Turbo
Ported Evo III 02 housing
DSS 3in, mandrel turbo back exhaust
Prothane motor mount bushings
RRE J-pipe
Greddy Big Frount mount intercooler
Dejon tool upper i/c pipes
Greddy-S BOV
HKS EVC 5 Boost controler
Magnecore wires
Injen Intake
RC 550cc injectors
Walbro 190 FP
Optima red top battery
Autometer EGT probe w/ gauge
Autometer Boost gauge
Gaugeworks Bezel pods

Transmission:
TRE-spec race trans.
TRE gear set
Prothane tranny mounts
ACT 2600 clutch
ACT light weight flywheel
Stainless clutch line
BG syncro shift
B&M short shifter
Greddy counterweight knob

Suspension:
Eibach Sportline springs
KYB AGX adjustable shocks
Tanabe strut tower brace

Other:
ADVAN A032R Drag radials
TPM Drilled slotted rotors
Axxis brake pads
Clear bumper markers
Injen chrome fuse box
Injen chrome spark plug cover
Injen chrome oil cap
Painted valve cover
Painted Intake manifold
Front Mud flaps

 

[GstRacer]

xylene
thats what i'm talking about didn't know too many people knew about that

 

[CatchMe]

shhh dont tell

 

[gixxer]

Sherman-Williams here i come