Can I reuse oil feed/return lines from Big16g on a bolt on 50trim?

[RedTurboEclipse]

hey yall.. i was just curious about this..

i currently have a big16g setup from rre with their install kit.. i was curious if i would have to get new oil feed/return lines if i got a bolt on t3/t4 50 trim.. and besides the obvious if there was anything else i would need to install it..

thanks

 

[DSMTurbos]

the 50 trim is probably going to have a t3t4 center section, you have a mitsu one, so it will not just bolt up. for the feed you could get a different adaptor to get to the turbo, but the drain isn't going to work

 

[joeym4130]

DSMTurbos is right, unless you have one of those 50-trims with a mitsu center housing ( i believe slowboy makes such a turbo). Otherwise the garrett centers are oil cooled

 

[hostile]

Is your oil feed line a stock one, or an ss feed line?