Water in my clear corners

[big green]

One of my clear corners has water in it. Looks crappy. I took it off and tried to use a hair dryer, but had no luck. Does any one know a good way to get the water out?

 

[gs-t]

Just take it out and let it dry. I ended up putting silicone around the bulbs once they were in, and over any area where the lens met the backing of the light fixture. Stopped the leaking.

 

[DSMhelex]

thats exactly what i did.... i used a hair dryer to dry it out, then took clear silicone and went over any place where air or water could get in...

 

[98_silvergs]

Dont buy the ones from APC

 

[Defiant]

Try the exhaust from a vacuum cleaner, necked down with some tubing to fit in there.

 

[Sinner]

I had this same problem, found out that the O-rings that go around the blub were dryrotted so I replaced the O-rings with new ones.

 

[InfamousEclipse]

I had this problem over and over, and I got some new o-rings and put the tightest possible ones on the bulbs, and haven't had a problem since