Can't get the fog light switch open!

[jrider]

Alright, I've been working on putting LED's in the interior, and have had no problems until now. I have just been popping open the switches and dropping the LED's in however best they fit. But the fog light switch is giving me trouble. If you look at the pictures I've attached, you can see how I think it is suppose to come out. The green board (yellow arrows) should just slide right out; well it doesn't budge. I can't even get the stock bulb (red arrow) to come out. I can turn it to unscrew it, but after that, I need to push from the top to pop it out; it is sitting flush with the plastic so there is no grabbing it with needle nose pliers. Pretty sad that I have to post for help on opening this little damn switch, but it has been getting the better of me for a day now. Any help would be awesome.

 

[jrider]

All that work on the post (pictures, explaination), and I get it apart not two minutes after I post. The stock light would not allow it to slide out. Just had to reach in and pop it out and the board slid right now .

 

[Airpoppoff]

you need to get a small tool to pry the tabs on the side out, then that switch you can push through the plastic, its cake after that