Projector Adjustment

[95WTSI]

Hey everyone,

I searched, but nothing helped. I am trying to adjust my projectors, but I cannot find where I adjust them horizontaly. I need them to move in a little cause all I can see is the grass on the side of the road... THanks!!

 

[95WTSI]

No one knows??!!

 

[svave]

So I installed my new projectors with angel eyes....but now the lighs are everywhere..the light on the right is way right, lighting up the grass on the right of the sidewalk when driving!!! How do I adjust this? I cant seem to find it...Also, the highbeems are soo high up that I flash 2 store houses at night when driving in the neighbourhood...HELP!!!

 

[Defiant]

It's easier to turn the knobs with your fingers instead of using a screwdriver. Give the mechanism a shot of WD-40, first.

 

[svave]

Isnt that one for the stock headlights? I got aftermarket projector ones...

 

[Defiant]

And they don't have the same, or similar adjusters? Did they come with any docs?

 

[EclipseGSX88]

I am having the exact same problem, and cant figure any realy way to adjust them except to take off the clear plastic cover where the level bubble is and adjust them that way. but still there is no horizontal or vertical adjustment that i can see. and my halo projectors are doing the same thing. My right now is tilted in towards the left so that the top right of my right projector light, is all upon people lawns and stuff and the right one go so high it blinds everyone when my left on is perfectly level, but still shines on peoples lawns, and the ones i bought, that were NOT off ebay off of a website that i pay 239$ for didnt comewith any paperwork, excpet for one paper telling me how to wire the halo in and that was it. PLEASE HELP SOMEONE

 

[EclipseGSX88]

I am having the exact same problem and cant find any help, someone please help me and him

 

[Slipstream]

I haven't found any adjustments for most projector style housings. I would suggest using washers on certain mounting screws and not others in an effort to tilt them in the direction needed, changing how tightly any given mounting screw is torqued down will also change their allignment. Failing that you might try shimming the needed areas to bring them back into line.

 

[Slipstream]

I am having the exact same problem and cant find any help, someone please help me and him

I just replied to the other thread you revived about this. I appreciate you searching for the problem but try to confine it to one area rather than this bizzare revival crossposting thing..it'll be easier for us to try and give you answers in a single thread.

 

[blackGSX2g]

Thats the problem with the aftermarket headlights, their build quality is often sub-par. My projectors came with the bubble leveler on them and I was able to level the low beams, but my driver side high beam was still way in the trees. It turns out the high beam reflector housing was out of alignment in the headlight housing. I just put an angled piece of metal through the hole where the bulb goes and knocked it back down.