alarm info?

[mkspriggs]

hey guys whats up?i just got a new alarm and it has atomatic start and all that fancy crap.but i have a manual car and no one will install it for me.so i will have to do it my self.this is the new alarm made for manual transmission so it wont be that hard but i cant find some of the wire.someone hellllllp!

+ ignition output [supplys power for the heater/air conditoning]
+ starter output [positive starter wire]
+12v ignition input

i have a 1990 gs and i think this is all i need for now atleast.

 

[jaxon23]

Mitsubishi Eclipse 1989-93 N/a
Wire Colors Location
12 Volts Constant Wht Ign Harness
Ignition 1 Blk/wht Ign Harness
Ignition 2 Blu/blk Ign Harness
Ignition 3 Na N/a
Accessory/heater Blower 1 Blu Ign Harness
Accessory/heater Blower 2 Na N/a
Starter Blk/yel Ign Harness
Parking Lights Grn/wht Gry Molex Near Hood Release
Domelight Red/grn Under Dash Courtesy Light
Pwr Door Lock Brn/wht Relays Left Of Steering Colm
Pwr Door Unlock Brn/blu Relays Left Of Steering Colm (type B)
Trunk Release Na N/a
Tach Sensor Wht At Power Transistor
Brake
Grn At Switch
Horn
Grn/blk Steering Colm

 

[mkspriggs]

thanks man ill try to put it all on and ill let you know later how it went

 

[mkspriggs]

just wanted to say the automatic start works fine and everything else is good to.but i have one more question.which is the wires that sense the door is open or closed,my locks work but this says there are wires for that and i need those bad.and also are you sure with the horn wire?i tried all i found and the horn never worked.ill keep trying though,3 times a charm thanks

 

[jaxon23]

thats just the wiring diagram i found online for your car...not much more help then that...sorry

 

[jepherz]

I'm not completely sure what you are asking when the door open wire is concerned. On my alarm, it was just sensing for ground. On the driver side of the car, there are two wires coming off of the switch by the back quarter panel. I think one of them was yellow, possibly striped, and the other was green and red i think. Anyways, figure out which one of these wires is grounded when any of the doors are open, including the trunk. Tap into that wire, and you should have a ground when any door is open.

The other thing with the horn is that the alarm could be putting out either ground or positive, make sure you know which it is putting out by testing it with a multimeter. then you have to figure out how the horn works. I believe there is a positive wire hooked to the steering wheel ONLY WHEN THE IGNITION IS TURNED ON and this wire is grounded by pushing the horn button. In this case, your horn will not work without the key (if this is what you are referring to)

I also have a wiring diagram that I used on my 1st gen alarm install, so if you need specifics, PM me and I can let you know or possibly take some pictures of the diagrams that you need.

Hope that helps

 

[mkspriggs]

alright i got it all installed thank you guys for everything and for anyone who does it the wire i was looking for on the door is green/red close to hood release.thanks