2G: Good Place To Buy 2.4 Pistons?

[InfiniteGSX]

So far all the sites I've tried, Cheapest I've found are Manley Forged 2.4 7bolt pistons for like 480. I'm on a severe budget and I don't doubt I can get 480 extra but how long it will take determines how long my car will be collecting dust.

I've so far tried. STM, MAP and the cheapest I found were from Extreme PSI.

[nitrouskris]

Morales Racing $450.00 and alittle cheaper for uncoated

[InfiniteGSX]

Nice thanks.

...website?

[WES_393]

Are you doing this for a turbo build or for an NT stock rebuild? Forged 2.4 pistons aren't going to be anywhere near cheap, especially with a lower compression ratio. Wiseco makes 8.5 and 9.0 CR 4g64 pistons, but they are over $500. Manley makes them as well at 8.5:1 CR with stock rod length, but the cheapest I have found them is a Built4g63.com for $469.

If compression ratio isn't an issue, just use some 86.5-87mm 4g63 pistons. But those in forged form will also run over $400.

[arrowhead]

Originally Posted by WES_393

Are you doing this for a turbo build or for an NT stock rebuild? Forged 2.4 pistons aren't going to be anywhere near cheap, especially with a lower compression ratio. Wiseco makes 8.5 and 9.0 CR 4g64 pistons, but they are over $500. Manley makes them as well at 8.5:1 CR with stock rod length, but the cheapest I have found them is a Built4g63.com for $469.

If compression ratio isn't an issue, just use some 86.5-87mm 4g63 pistons. But those in forged form will also run over $400.

What CR would those 4g63 pistons bring?

[InfiniteGSX]

Originally Posted by WES_393

Are you doing this for a turbo build or for an NT stock rebuild? Forged 2.4 pistons aren't going to be anywhere near cheap, especially with a lower compression ratio. Wiseco makes 8.5 and 9.0 CR 4g64 pistons, but they are over $500. Manley makes them as well at 8.5:1 CR with stock rod length, but the cheapest I have found them is a Built4g63.com for $469.

If compression ratio isn't an issue, just use some 86.5-87mm 4g63 pistons. But those in forged form will also run over $400.

Will 86.5 4g63 Pistons work in a 2.4? And yes for turbo, is there anything else? lol My Engine spun a bearing, I got a low mileage 2.4DOHC but need pistons. Because I don't feel very happy about being limited to severe low boost.

I've been looking at the Manley 4g64 with 63 Head Pistons. Cheapest I found was 480. I don't care if they aren't going to be cheap, I'm asking for the cheapest place anyone has seen. You've said 469, I've found 480. I need forged Pistons.

If I can run 86.5mm 4G63 Pistons then that will help me out.

LMK please. I haven't looked much into the 2.4 setups yet because I wasn't expecting to get an engine this fast.

[nitrouskris]

Originally Posted by InfiniteGSX

Nice thanks.

...website?

www.MoralesRacing.com