How hard is it to install clutch master and slave cylinders???

[red98gst]

I couldnt find anything on how to install thses on a 2g, so can someone exlain how hard it is to do? or should i have a mechanic do it? thanks

 

[90DSMTurboFWD]

According to this not to hard:

http://www.plymouthlaser.com/masterc.htm

 

[Boostin16gGSX]

i did one bout 2 yrs ago on a 2g....the slave cylinder isnt hard at all....but the master cylinder will give u a lil more trouble...as long as u have the right tools u wont have to worry bout anything....

 

[red98gst]

DO i have to get the car on a life for the salve cylinder? is there any sites showing the salve install?would the haynes manual have this in there? also, how do i bleed everything like its said??? sorry for all the questions.

 

[Boostin16gGSX]

u just have to jack it up a lil from the front to get to the slave cylinder.....the haynes manual shows everything on how to do it too...as for the master cylinder just be prepared to get ur hands in some tight places......also to bleed it just make sure the bleeder on the slave cylinder is closed.....put some fluid in....pump the clutch 5 times and hold it down...then open the bleeder and close it again.....just keep repeating that process till all the air is out of the line....ull know the air is out when its just fluid that comes out.....

 

[90DSMTurboFWD]

here is the Slave
http://www.plymouthlaser.com/slave2.htm