Getting closer!!

[craracer05]

Well i'm getting closer and closer to finally getting my setup on. I just wanted to list everything that have and what I planning to get and see if theres anything i'm forgeting.
Right now my car is intirely stock. I ahve sitting in my bedroom right now a SBR g50 ported turbo,brian crower 272s,turbo oil lines,arp head studs, Mitsu MLS head gasket,timing belt and tensionor, 2.5" tubular o2 housing with atmosphere dump, 3" downpipe, Apexi n1 turbo muffler,ebay FMIC, Upper intercooler piping.
I plan on gettin 1000cc injectors, DSMlink, 90 eprom ecu, fuel pump,exhaust mainfold,valve seals, not really sure what else.( i know i'm probably going to need a clutch,but tryin to avoid it because i really want a shep tranny ### my second gear is starting to go) Just looking for some input.

 

[craracer05]

My other question was about how much boost do you think the stock internals will handle with this setup, I compression tested at 150 on all cylinders.

 

[dsm91TalonTSi]

with my old evo3 16g with stock motor, i safely ran 18psi on 93 octane... i did have the walbro 255fp tho

 

[esoung]

you need to do engine internals to get the performance of the parts you already have.

 

[staticbrainwash]

you need to do engine internals to get the performance of the parts you already have.

Since when? The stock block can easily take 350-400hp.

 

[craracer05]

I thought i'd be alright up to 400hp too. My big thing is i have another 6-bolt motor in the garage i'm going to be building for next year, so i figured this setup will hold up until then.