installing engine help

[snowboarda10hal]

I couldn't find anything but i was wondering if it would be easyer for me to drop a new engine in with the tranny in it already, or out the tranny in after the engine was in the car?
Also how many moter mounts are there and where are they?

 

[95AWD6Bolt]

It is easier to drop the engine in the the tranny attached.

 

[snowboarda10hal]

thanks

 

[c4uldr0n]

There should be a total of four engine mounts... (Front, Rear, Transmission and Driver Side)

 

[snowboarda10hal]

Whats the best way to take the engine out? I took the nutt off the side engine mount but the screw wont pull through and its tuff getting a hammer in there to pound it threw?

 

[eldiabloz13]

vfaq.com go to engine and ## all set.

 

[EVOL_TURBO]

I found it best to drop the motor and trans down, unbolt the trans, and then pull the motor without the trans back up through the top.

SO, FOR INSTALL... I did the reverse, engine down through the top, bolt trans on, and then bring both back up to the mounts.

 

[TSG59_Steve]

This is how I did it: http://www.team-2g.com/mitsubishi-eclipse/showthread.php?t=19053

Went pretty smooth.