What parts are changed when installing a camber kit on a 2G?

[DSM91]

I have a FWD 2G that has the Ingalls camber kit installed. I am trying to remove the kit but I am not quite sure what stock parts I need to bring it back to stock.

The upper arm has two points where it connects to the car through the engine bay. There are two anchor bolts there that aim straight up toward the hood. Do both of these bolts on both side of the car need to change? Or just the bushing? I have searched all over the place and can't find the answer. Since nobody seems to have these stock parts left over I have to order them new from the factory.

Thanks for any help.

 

[FORMONTOYA]

i do not know exactly what the part is called, but you are correct. on the front there is 2 attachment points on each side, it consists of a bolt type thing with an "eye" with a bushing inside it. the ingalls that you have is a bolt type thing with a slot and bushing on it. if you have the kit on the back, then there will also be 2 attachment points, a U shaped piece. if you go to the dealer they will have a picture that you can look at on screen to get the exact part.


jim

 

[DSM91]

Thanks Jim.

I went to the local junkyard and bought two upper control arms with all 4 bolts included for $40. Not bad.

For one anchor bolt it would have been $45 from Satan, so I think the junkyard was the way to go.

Thanks for the help.