stalling w/XACT streetlite flywheel

[nh98gsx]

Just installed the ACT2100 w/XACT streetlite flywheel, now when i pull it out of gear from a higher rpm (3k) and put it into neutral the car is stalling on me. I know why the lighter flywheel isn't holding the enertia, but what can i do to prevent it. Will adjusting the BISS screw solve the problem or just cause my car to idle to high?

Please help ASAP..

 

[boostle]

Did you reset you ecm yet? Mine usually takes a few minutes (15 maybe?) of driving before it figures out the catch point with my Fidanza.

 

[leet]

My car does not have that problem with the Fidanza. How many miles have you put on with the XACT Flywheel?

 

[nh98gsx]

i had just finished it yesterday afternoon and had 5 miles on it, it has sence stopped stalling but i threw a cel the codes are P0125 and P0170, "excessive time to enter closed loop fuel control and fuel trim malfunction", WTF. Can some one please let me know what the f. I should do.

 

[boostle]

Did you forget to connecto any sensors? Temp sensor? You can search on closed-loop operation but there are a few parameters that must be met like coolant temp, baro...other stuff.

 

[nh98gsx]

i think the temp sensor wasnt on all the way would that cause both codes, also my temp gauge was working fine, i have logger what parameters should i check out?

 

[Rodman]

I forgot to hook up the mas after the install, did the same thing

 

[hostile]

It is either your o2 sensor or another sensor not connected.

The stalling should go away after you get some running time on the ecu.

Make sure everyhting is hooked up that you took off when you did the cluthc flywheel swap.