RPS Clutches SUK

[the1cancer]

Never buy an RPS clutch kit. They make their pressure plates 1/4" taller than stock, causing the fingers on the pressure plate to force the clutch fork against the back of the bell housing. This causes the fork knock against the pressure plate damaging the fork and the slave cylinder since it forces the end of the fork against the slave rod continually.
Pre-mature clutch disc wear will occure since the pressure plate is continually slightly enguaged.

P.S. RPS SUX

P.P.S. They refuse warranty returns or replacement. They will just try to sell you another one.

 

[jasonlee]

hmm... i wonder if it was mabye too tall of a throw out bearing? just a thought

 

[the1cancer]

hmm... i wonder if it was mabye too tall of a throw out bearing? just a thought

It could be, i dont know anymore. all I know is I bought everything (except for the clutch) from the mitsu dealer.

I compaired my stuf with my friends OEM stuff and it looked the same.