boosted240
15+ Year Contributor
- 478
- 14
- Dec 25, 2006
-
ocean city,
Maryland
So finished the last setup and didnt make the power i wanted so i was sittin at the shop messin wit the shop car and decided i was just gonna get serious and do a good build. So here it is.
6 bolt block
Groden aluminum rods
CP Pistons with upgraded wrist pins
ACL race bearings
ARP main, head studs
L19 head studs
o-ringed block with receiver groove in the head
cometic HG
Ported head done by us at pollo performance
Full race trans done by us
Our intake manifold
BSE
HKS cast mani
HKS 50mm racegate
40r turbo
Supertech duel springs, retainers
Supertech nitride valves
Bronze guides
BC 280 cams
Aem tru time cam gears
AEM EMS
Turbosmart e-boost
1600 injectors
either dual bosch 044 pumps or a weldon. Not sure yet
Fiberglass doors, hood and back hatch
Most likely a tilton carbon carbon twin disc
Kyb agk with hypercoil springs
DSS rear axles
DSS driveshaft
The rods and pistons will be here in about a week, the turbo and wastegate are already here. Will post pics as soon as i go take some. Will keep everyone posted
6 bolt block
Groden aluminum rods
CP Pistons with upgraded wrist pins
ACL race bearings
ARP main, head studs
L19 head studs
o-ringed block with receiver groove in the head
cometic HG
Ported head done by us at pollo performance
Full race trans done by us
Our intake manifold
BSE
HKS cast mani
HKS 50mm racegate
40r turbo
Supertech duel springs, retainers
Supertech nitride valves
Bronze guides
BC 280 cams
Aem tru time cam gears
AEM EMS
Turbosmart e-boost
1600 injectors
either dual bosch 044 pumps or a weldon. Not sure yet
Fiberglass doors, hood and back hatch
Most likely a tilton carbon carbon twin disc
Kyb agk with hypercoil springs
DSS rear axles
DSS driveshaft
The rods and pistons will be here in about a week, the turbo and wastegate are already here. Will post pics as soon as i go take some. Will keep everyone posted
