2G Oil cooler question

[lowavenger96]

I'm doing a 6 bolt swap into my 95 talon . The motor I bought fron the junk yard had an oil cooler on it but the person who pulled the motor trashed it. I still have my oil cooler off the 95 but the filter houseing is differnt so I was wondering if you can swap the whole houseing . If not I'm going to go with a perma cool 10695 kit and use an air cooler with it , but to be more cost effictive i would like to use the 95' s oil filter houseing...

 

[NDgsx]

Nope, different bolt patterns.

What about some type of thermostat for the oil cooler? An easy way to run your cooler would be to get a 90 filter housing, which has a built in thermostat and two M16x1.5 outlets for air/oil cooler lines.

 

[lowavenger96]

Ok I found the solution to my problen I'm going to get a Perma_cool 10695 remote oil filter kit and a air cooled oil cooler.

 

[NDgsx]

You still need some type of thermostat otherwise the oil will never come up to full temp. I think www.racerpartswholesale.com has a couple models that you could plumb into your lines.

 

[chaye]

why dont you do what im doing? I ran into the same prob as i did i bought the engine from the junk yard without a oilcooler but i managed to buy an oil cooler of the board for like 65 shipped with everything
i think that was cheaper than a aftermarket one


btw...i want to know how your are planing on installing that air to air oilcooler?
im a bit stumped... i mean i have ideas but no how tos...
thanks man
email me
[email protected]