Anyone running 35mm Tial on Green?

[Violater101]

and do you have any problems at low boost ie 15lbs.
Also, what size spring 1 bar?

Thanks

 

[larryd]

im sure youve already read it but FP says you should use a 40, they told me the same thing over the phone if it matters

 

[Violater101]

Yah, I have :> They also said I could get away with a 35 if I didn't plan on ever running lower amounts of boost. I will run 20lbs of boost daily on this turbo once I get a few more goodies which I don't already have (bigger injector's and AFPR). It's just an additional $175 that I could spend elsewhere :< Plus, I've seen pictures with a 35mm that seem to be the the stock a/c fan in place. With a 40mm, It's definately going to have to go. I was mainly wondering if anyone had tried before I go ahead an order the 40 so I can get it shipped to AHP so that the flange can be put on the tubular O2 i'm getting from them.

 

[Violater101]

I guess not

 

[DSMotorsport]

I run a 50 trim t3t4 garret, with a 35mm tial mounted on the cast manifold runner #1...I have run 13psi (spring pressure .8bar) up to 7500rpm in 3rd no problem..no creep. IMHO the 35mm gate is fine.

 

[larryd]

i would just take FPs word on it, if you dont have to worry about ever running low boost then the 35 would be fine.