PCV Valve Threads? 1/8" BSPT 28 tpi

[ksalas]

Hi

Please some one can tell me what metric size is the srew on the PCV valve ?

12mm 1.5 ?????

14mm 1.5 ?????

16mm 1.5 ?????

Thank You....

KS

 

[andymoraitis]

You needn't bother with metric. It's 1/8" NPT. Run a tap through it and you're good.

 

[ksalas]

Excellent, I believe was metric, now I will get a 1/8 NPT to AN -6 Fittings for the Oil Catch Can....

Thank You !

Regards...

KS

 

[andymoraitis]

No problem. Have fun and just make sure you tap that sucker straight.

 

[Spyder FX]

The PCV valve hole on the VC is a 1/8" BSPT with 28 threads per inch. The 1/8" NPT have 27 threads per inch. Just be sure to Re-tap it before you try threading a 1/8" NPT fitting in there.

If you must use -6 line ignore this. But I just used one of the vacuum fittings off the stock intake manifold and it screws right in, since the threads are identical to the PCV valve's threads. But I also use normal fuel hoses with clamps on my oil catch can setup.

 

[ksalas]

You are the Men !!!! I can't get out the VC right now and I can't Re-tap, but let me know if I can used this and all will be done....

www.summitracing.com Item: ATM-2269

Thank You so Much.....

Regards !

KS

 

[Spyder FX]

That adapter will work, just pick one of these to use too http://store.summitracing.com/egnse...94849624+4294906672+4294906726+115+4294906752

 

[ksalas]

I all ready select one of this.....

Thank You !

KS