need some quick opinions

[ZigsGSX97]

Hey, I'll get right to the point: just put a 1g throttle body (w/ brand new shaft seals) in my 2g AWD. Also got my int manifold ported along with my tb elbow. AND I fixed all my boost leaks (I had a lot of them). Now after all is said and done, my car feels slower and the turbo takes a lot longer to spool up. Should I get my car retuned because I have more airflow? (I use an SAFC 2) Keep in mind I have no boost leaks right now.

 

[1992awdlaser]

Did you check to see if the throttle plate was opening all the way with the gas to the floor?

 

[hopeformylife]

That sounds like a good place to start. Check to make sure your floor mats aren't stopping the pedal from going all the way down.

 

[ZigsGSX97]

Yes the throttle plate is opening 100%. The carpet is not in the way. I got new cams goin in, so I'll just get it retuned after that

 

[brute]

What about a preturbo exhaust leak?

 

[GSTdude06]

Make sure your timing is correct also since you just got cams put in. Coulda advanced or retarded timing some.

Make sure you dont have boost leaks.....test n retest with soapy water.

 

[1992awdlaser]

If you used one of the sensors off of the 1g maybe it is bad.

 

[ZigsGSX97]

nevermind.......it's running awesome now. I think the computer needed to readjust everything. Only thing that kinda irritates me with this 1g tb is when I go to start it cold, it idles at almost 2,000 rpm, then after a few minutes it goes down to 850 where I want it. WTF