Safc2 throttle problem

[spoolintsi97]

The problem that i am having with the Safc2 that i just installed is that when i push the trottle in it reads 100% no matter how far in i push it. It reads a 100% at 1/4 throttle, 1/2 throttle and any other time it is pushed in and when its closed it reads 0% like it should so if anyone knows what is going on that would be great

 

[eclipsegsx1736]

Somewhere in the settings, it might be under "etc." is an option to select # of cylinders and next to it it says "Thr" for throttle. make sure the cylinders is set to 4 for a 2g, and the Thr should be set to the arrow pointing upward. If its reversed then, i.e. flooring it reads 0 and letting off reads 100%, then have the arrow point the other way. Hope this helps? Sorry, I have the SAFC1 but it should be the same.

 

[spoolintsi97]

Yea there all set right i have know idea what it is except i didnt understand the learing the throttle that they tell you to do in the inital setup maybe this could be it if someone could expain that to me thanks

 

[oddrob]

Go to the sensor check and check the throttle voltage and see if its flakey as well.

 

[spoolintsi97]

It reads .010 off and when u push in the trottle no matter how far it reads 4.5

 

[spoolintsi97]

could the throttle senser be bad and sending the wrong signal