From Home Depot Racing comes the 1g DSM Lip oooooo ahhhhhhh oooooo ahhhhhhh :p
Parts you need to buy:
Quantity 7 Part # 590913 - Cost 0.84$
Quantity 7 Part # 655430 - Cost 0.84$
Quantity 1 Part # 09355216305 RESEDG30'BPK - Cost 8.98$
(20ft and 30ft lengths same price for the liner)
Tools:
Drill and a bit 5/16 <-- you should already have... if not like 20$ for cheap set.
Expierence:
none but You need to be careful while drilling because if you are not steady or the bumper is
not secure the bit catchs the bumper very easily and will put a huge hole in it shorter then it
takes for your drill to spool down.
Where to drill:
2 drill holes on each very edge near the tire of the bumper...
2 near the start of the corners... 3 spred out evenly in the front of the bumper...
you want to angle it a little up so the lip comes out... or you can angle it however you want...
Time:
Took about 30 minutes...... Although about 1 hour if you include taking off your bumper and
putting it back on... my bumper was already off and i didnt have to put it back on 100%
Link to Pictures:
http://www.dsmtuners.com/forums/showthread.php?t=168972
