Quote:
|
Originally Posted by jshuman
If you are familiar with dsmlink, you know that the boost est curve is supposed to fall away from the actual boost curve around 5-6k rpms.
|
It is supposed to match from 6,000 and below. After 6,000 boostest is supposed to fall off from actual boost.
Zero out your 2400hz slider, it shouldn't need to be touched.
If your logged wideband redings are correct, I would richen it up some if you are on pump gas.
Post another log after you zero out the 2400hz slider.
Just to verify you translator settings are as follows:
Aux:4
Base:2
Mode switch 1: off for 3" maf, on for 3.5" maf
Mode switch 2: off
Mode switch 3: off
Mode switch 4: off
Idle, mid, wot knobs: 0
Edit: scottsee and blcknspo0ln, the second picture in this link shows what the curves should look like.
http://jeffgst.com/boostestcurve.html