Thread: 16g flapper help
View Single Post
Old 05-07-2008, 08:28 PM   #1 (permalink)
Empir3 X
Proven Member
 
From: Centerville, Ohio
Region: Tri State
Registered: Oct 2006
Posts: 51
Classifieds Rating: (1)
Reputation: Empir3 X is an unknown
16g flapper help
I just received a fully ported 16g from a private sale on the classified section of the site, and upon inspection i have noticed that the flapper seems to have been pressed to far in. A sliver of the waste gate passage hole is visible when the flapper is shut. Can i just go to a machine shop and get the flapper pressed back 9-10mm or what should i do.....Its a big disappointment due to the fact its holding my build up, and I am not sure what to do with my car already taken apart.



Any ideas thoughts will help

Thanks, Alex
Last edited by Empir3 X : 05-16-2008 at 05:10 PM. Reason: correction
Offline  
[posts] [gallery] Reply With Quote
Related Auctions