nickrule99
15+ Year Contributor
- 502
- 0
- Jun 14, 2003
-
Greenfield,
Massachusetts
I've gotten everything I need to rebuilt a 6 bolt, all I need now is bearings.
I was pretty set on getting some Clevites, but I've seen some bad stuff on here about them not having strict factory tolerances. What bearings would you use if you were rebuilding your engine?
The engine has Eagle Rods and Ross Pistons. Its not going to see rev's higher then 8000, if that, and it will be supported by a 60-1 or a 50 trim turbo.
I cant decide between OEM, Clevites, ACL, and I saw someone mention Kings in another thread.
Thanks for the advice in advance.
-Nick
I was pretty set on getting some Clevites, but I've seen some bad stuff on here about them not having strict factory tolerances. What bearings would you use if you were rebuilding your engine?
The engine has Eagle Rods and Ross Pistons. Its not going to see rev's higher then 8000, if that, and it will be supported by a 60-1 or a 50 trim turbo.
I cant decide between OEM, Clevites, ACL, and I saw someone mention Kings in another thread.
Thanks for the advice in advance.
-Nick