The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support STM Tuned

Transmission Instal Part 2

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

1.Support the transaxle assembly by using a transaxle jack.

You must be logged in to view this image or video.


2.Remove the connection bolts while turning the crankshaft.

You must be logged in to view this image or video.


3.Chalk mating marks on the flex plate and clutch pressure plate for easier installation.
4.Press the clutch pressure plate into the transaxle for easier removal.
5.Remove the transaxle assembly mounting bolt and lower the transaxle assembly.

You must be logged in to view this image or video.


INSTALLATION SERVICE POINT


(A) CENTER MEMBER ASSEMBLY INSTALLATION
If the dimension shown in the illustration is outside the standard value when the weight of the engine is on the body, replace the front roll stopper bracket assembly.

Standard value (A): 43 ±3 mm (1.69 ±.12 in.)



(B) DRIVE SHAFT INSTALLATION
Temporarily install the drive shaft so that the TJ case of the drive shaft is perpendicular to the transaxle.

CAUTION: Do not damage the oil seal lip by the serrated part of the drive shaft.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top