GregoryRyan
Supporting Member
- 167
- 113
- Jul 22, 2013
-
Millstadt,
Illinois
This thread is for the general discussion of the vehicle Rust to Track. Please add to the discussion here.
Last edited:
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Yeah I think it turned out pretty good, feel free to reach out if you have any questions.I'm going to have to do the headliner too, your way looks nice.
Are you going to offset the seat on top of the sliders?
Yeah, the darn seatbelt tab. I prefer the cut and tap method I did on the drivers side, not that I'm using stock recievers, but the height on the wedge bracket is right up in the side of the seat fabric.Yeah I think it turned out pretty good, feel free to reach out if you have any questions.
And I requested the Sparco customization from WEDGE when I ordered them so as far as I can tell the sliders and everything lines up as Id like them to. Only thing I don't particularly like is the seatbelt placement once I bolt the stock receivers onto the WEDGE brackets, I feel like the sit to far forward and look a bit off.
Yeah I had to dump a ton of heat and pound the bracket away from the seat to get it to stop gouging into the fabric. Overall the brackets are nice they just need a few tweaks.Yeah, the darn seatbelt tab. I prefer the cut and tap method I did on the drivers side, not that I'm using stock recievers, but the height on the wedge bracket is right up in the side of the seat fabric.