dannydiazdsm2g
Probationary Member
- 4
- 1
- Jan 24, 2021
-
Summerfield,
Florida
Ok.. so iv been all over the forms and can't seem to pin point an answer. So I'm writing a new thread. I have a 420a with stage 2 internals. My issue is at idle and while driving I'm seeing 50 to 69 oil psi. Is this normal??? Also my afr gauge flat lined too.. am I about to blow the motor to shit. Read somewhere that it depends on the gauge itself aswell I'm running a aem oil gauge. Sorry if I'm asking a dumbass question. But I would like to know if the reading is fine or do I have something wrong. Bad ground?? Improper location?? I have my sensor installed on the back side of the block where the stock sensor was I have a T fitting for my oil feed line for my turbo aswell but don't have it installed atm.. Motor doesn't leak any oil at all. And I just replace all the seals aswell.
You must be logged in to view this image or video.