No start

[beihl304]

Today I decided to install the clutch wire for nlts/shutterbox. I cut pin #91 on the ecu and the green wire on the clutch switch. I connected all connections as said on dsmchips and now my car will not start. I decided to put everything back to normal and it still don't start. My question is if u cut the green wire on your clutch switch, will u car still start? If not I may not have a good connection due to where it is at. If it still should than I'm stumped

Anybody

 

[gofer]

Today I decided to install the clutch wire for nlts/shutterbox. I cut pin #91 on the ecu and the green wire on the clutch switch. I connected all connections as said on dsmchips and now my car will not start. I decided to put everything back to normal and it still don't start. My question is if u cut the green wire on your clutch switch, will u car still start? If not I may not have a good connection due to where it is at. If it still should than I'm stumped

Anybody

On a 2g your supposed to cut the black wire with a red stripe on the clutch switch...

http://www.ecmtuning.com/downloads/docs/2G%20Clutch%20Wire%20Instructions.pdf

Go over the install procedures again...

 

[beihl304]

Thanks, I was looking at 1g procedure but I was told it was the same besides the pin number... But Ill have to do that.