We're on Boost
15+ Year Contributor
- 2,132
- 870
- Aug 25, 2007
-
Seattle area,
Washington
My CrankingFuelAdj seems to not be working at all.
When I change the settings in the table it makes no difference in my InjOn time or InjDuty, either one, during a cold start.
So I started logging CrankingFuelAdj. Sure enough, the logged value for it is always just 0.
What could the problem be?
There are one or two odd things about my ECMLink setup. For example I’m speed density without an IAT sensor.
Could you guys take a look at this cold start log and see if there is some reason for getting nothing from Cranking Fuel Adjust?
I’m getting 4 to 5 ms InjOn time during cold starts. I’d like to get that up to 7 or 8 ms.
Firmware version 3.36.64
ECMLink software version 3.36.73
Laptop, Windows XP with Service Pack 2
Hmm, how do I post a log here?
When I change the settings in the table it makes no difference in my InjOn time or InjDuty, either one, during a cold start.
So I started logging CrankingFuelAdj. Sure enough, the logged value for it is always just 0.
What could the problem be?
There are one or two odd things about my ECMLink setup. For example I’m speed density without an IAT sensor.
Could you guys take a look at this cold start log and see if there is some reason for getting nothing from Cranking Fuel Adjust?
I’m getting 4 to 5 ms InjOn time during cold starts. I’d like to get that up to 7 or 8 ms.
Firmware version 3.36.64
ECMLink software version 3.36.73
Laptop, Windows XP with Service Pack 2
Hmm, how do I post a log here?