The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support Fuel Injector Clinic

Lotek A Pillar install & Autometer Ultralite II Q.

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

esoteric

10+ Year Contributor
160
0
Jul 19, 2010
PA, SK_Canada
What size drillbit am I going to need for this? I am 100% retarded when it comes to drills and screws, so if anyone has done it or just someone not retarded in general how do I match drill bits to screw size?

Also for the autometer since I am also completely retarded with electronics, I am going to use 12g wire but are there clips I can crimp on one end to plug into the prongs on the back or do I solder the wires onto there? Also is there a less abrasive way to attach the wires to a 12v source and ground other then cutting the wire soldering and taping? No clips that I can splice and crimp?

Tried searching but every thread had pictures instead of info and they weren't active anymore :(
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top