- Thread starter
- #176
95FullSend99
Proven Member
- 382
- 200
- Dec 3, 2019
-
ledyard,
Connecticut
Alright. So while waiting for the noid lights to come in, I tested for continuity through the circuit just to make sure everything was connected where it should. I also verified that I saw 12v at each wire at the injector like I should. Check. And there tested resistance accross the injectors which were all within spec at 8.7-8.9 respectively. I also placed a large wrench on the injector and my ear against the wrench in the hope to hear them clicking. Nothing.
Noid lights came in after that and lo and behold they flash like they should.
So with that, my injectors are the issue. I'm pulling them today and I'm going to try and get them to fire with a 9 volt battery. If that doesn't work I'm sending them off to FIC.
Noid lights came in after that and lo and behold they flash like they should.
So with that, my injectors are the issue. I'm pulling them today and I'm going to try and get them to fire with a 9 volt battery. If that doesn't work I'm sending them off to FIC.