Installing my ultra stiff shifter under hood bushings kit

[gst fat]

Ok so I bought the brass kit that comes with the 2 solid brass inserts and 2 c clamps and little peice of sand paper.

Anyone have this and it didn't come with instructions, I know it's easy to install, but someone shoot me a little help, I did do a search but came up empty handed

 

[DSM nOOb]

rip cut burn however you have to get the old ones out get them out. Sand the area smooth where the old ones were. then use a c clamp or vise to press the new ones in

 

[gst fat]

I know that but exactly where are the old bushings at exactly? Can someone post a pic

 

[DSM nOOb]

Instructions
its right below the intake on the transmission

 

[gst fat]

Thanks alot that's what I needed!

 

[twicks69]

As well, make sure that the brass bushings are not a PRESS-FIT ONTO the shift levers - They should be a tight fit INTO the shift cables - use a bit of emery paper or 600-1000 grit sandpaper to smooth the bushings and pins out if necessary. Then, use Anti-Seize on the shift levers so that the bushings are still tight, but freely rotate.

Good luck, it isn't that hard to do if the bushings are not seized to the shift levers.

 

[gst fat]

They were installed today and took no more than 10 minutes

 

[bsbllfit7]

how does the shifter feel after the install? Im contemplating doing these right now actually, cept im ###### gonna go the skateboard bearing route