CODE4
15+ Year Contributor
- 427
- 44
- Jun 6, 2004
-
Tampa,
Florida
Need something that can make clean cuts on OD up to 3" - anyone have any experience? I do not need anything that is on a full stand or for 100% duty cycle type shop use, but I need to make about 150 cuts in the next month on a project notching 2.5" and 1.5" sch 40 pipe.
I see several models out there that chuck up the pipe (with varying angle adjustability) and provisions for attaching a common drill head to spin the hole saw blade.
I only need a 90* cutting ability, but anything more is a bonus.
I am sure there is a price point/break I need to hit before the cost/benefit tapers off, but I am hoping someone here has had good experiences with a particular brand.
I see several models out there that chuck up the pipe (with varying angle adjustability) and provisions for attaching a common drill head to spin the hole saw blade.
I only need a 90* cutting ability, but anything more is a bonus.
I am sure there is a price point/break I need to hit before the cost/benefit tapers off, but I am hoping someone here has had good experiences with a particular brand.