DeNoZZo
10+ Year Contributor
- 685
- 1
- Jul 6, 2008
-
Waterloo,
Iowa
Can you guys share your tips and tricks for getting the block/crank cleaned before assembly? I was told to rinse every thing with lots of brake fluid, and/or wash everything with hot water and soap.
-Is it necessary for me to remove my balance shaft oil blockoff bearings? The motor suffered a spun rod bearing so I don't know if there are shavings that would get trapped back there. Or will it be adequate to use brake clean/compressed air to blow out the hole?
-Is it necessary for me to remove my balance shaft oil blockoff bearings? The motor suffered a spun rod bearing so I don't know if there are shavings that would get trapped back there. Or will it be adequate to use brake clean/compressed air to blow out the hole?