TCB91GSX
Proven Member
- 258
- 240
- Jan 11, 2021
-
Denver,
Colorado
Good Evening Tuners,
I was hoping to grab some insight on the set up I am intending to do for my AEM MAP sensor.
I have a K-Tuned adapter that is BSP to BSP w/3 NPT threaded slots around the radius of the plug. I intend to pull my brake booster nipple, screw the K Tuned adapter in then replace the nipple to the booster on the back side and run the MAP sensor off the side. Fitment checks out, however I was wondering if the following would be an issue. *Please see pictures.*The MAP sensor and the nipple threads do not touch, the nipple is just partially over the map sensor inlet. I am thinking that since this small chamber will be full of pressure that it will be a non-issue, but I am open to hearing some input.
Thanks for taking a look!
I was hoping to grab some insight on the set up I am intending to do for my AEM MAP sensor.
I have a K-Tuned adapter that is BSP to BSP w/3 NPT threaded slots around the radius of the plug. I intend to pull my brake booster nipple, screw the K Tuned adapter in then replace the nipple to the booster on the back side and run the MAP sensor off the side. Fitment checks out, however I was wondering if the following would be an issue. *Please see pictures.*The MAP sensor and the nipple threads do not touch, the nipple is just partially over the map sensor inlet. I am thinking that since this small chamber will be full of pressure that it will be a non-issue, but I am open to hearing some input.
Thanks for taking a look!
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
Last edited: