DarkMatterM4
Probationary Member
- 12
- 6
- Dec 15, 2020
-
Philadelphia,
Pennsylvania
Hi all,
I'm replacing my 3-4 shift fork and I got most of the transmission back together. I just finished torquing the 36mm nuts (109 ft-lbs)on the intermediate and input shafts and was about to put the end case on. At this moment, I noticed that I am no longer able to spin the gears by hand. I loosened the nuts and I am again able to spin the gears. Why is this happening and how can it be fixed?
I'm replacing my 3-4 shift fork and I got most of the transmission back together. I just finished torquing the 36mm nuts (109 ft-lbs)on the intermediate and input shafts and was about to put the end case on. At this moment, I noticed that I am no longer able to spin the gears by hand. I loosened the nuts and I am again able to spin the gears. Why is this happening and how can it be fixed?