Dsmpagan
Proven Member
- 130
- 5
- Oct 29, 2013
-
Wolcott,
Connecticut
I replaced by fuel pump, the fuel pressure is supposed to be like 40-43psi correct? After changing to the Walbro 450 my FPR gauge now reads like 25psi and even when I adjust it never climbs much higher than that. Could I possibly have installed it incorrectly?
Also there is an ever so slight leak at where the hard line coming out of the fuel pump assembly meets the fuel line and i can't seem to get it to stop. I am worried that if i tighten any more i will bend the hard line. I know i can't use Teflon tape because of the fuel but is there something similar?
Does anyone make an aftermarket single pump hanger that loses the breakable hard like on the assembly?
Thanks in advance.
John
Also there is an ever so slight leak at where the hard line coming out of the fuel pump assembly meets the fuel line and i can't seem to get it to stop. I am worried that if i tighten any more i will bend the hard line. I know i can't use Teflon tape because of the fuel but is there something similar?
Does anyone make an aftermarket single pump hanger that loses the breakable hard like on the assembly?
Thanks in advance.
John
Last edited by a moderator: